We have 22 in stock.
With 38 pockets inside and out and a center panel design, the Tech MC has two storage bays with ample room for hand tools, meters, and a compact cordless drill, as well as smaller tool and accessories. It also includes D-rings, bit extension and memory stick pockets, and a stainless steel tape clip as well as a quick access outside pocket for drill bit extensions and small items. An over-molded ergonomic grip and a 3" wide padded shoulder strap provide comfort for a potential load of 50 tools.
The Tech MC follows the tremendous success of the Tech MCT. While the MCT allowes for two more inches of vertical storage space, many customers asked us to make a MC in a fully featured Tech Series style; THE TECH MC DOES NOT STORE LONG SHANK TOOLS. The Tech MC and Tech MCT offer technicians the ideal platform for various service, repair and installation bags, and many customers are setting up dedicated bags for their various types of work” said Roger Brouard, founder of Veto Pro Pac and the designer of the Tech MC.
PRODUCT SPECIFICATIONS:
MAXIMIZED TOOL STORAGE CAPACITY:
RUGGED MATERIALS & CONSTRUCTION:
OTHER FEATURES:
Keep the Zippers Clean & Lubricated
Over time, dirt and grit will “clog” the zipper coils preventing them from staying closed. To keep this from happening, clean and lubricate your zippers twice a year (more often if you work on a job site with a high amount of airborne debris). To clean the coils: Scrub them with soapy water; a tooth brush works very well. After scrubbing the coils, blow them out with an air hose to dislodge any other fine grit that didn’t dislodge with the brush. To lubricate the coils: Apply a silicone spray, beeswax or a zipper lubricant.
Protect the Zippers From Sharp Objects and/or Excessive Heat
Any sharp object or heat source is capable of permanently damaging the zippers. Once a zipper coil is cut or singed the zipper will not function and in most cases is not repairable. Most of the cut zipper coils we see are the result of sharp tools stored inside the bag with the sharp side facing up. Make sure to keep the sharp edges of your tools facing down in your bag and away from the zipper coils.
Don’t Overstuff the Bag
Overstuffing your tool bag will very likely cause significant stress on the zippers that is above and beyond what the bag was built for and will eventually cause the zipper(s) to separate. If you have to work hard to close your zipper(s), your tool bag is most likely overstuffed… proceed with caution!
